I see so much info about printing with larger nozzles and such. Not much on smaller. Is there anything I should worry about that I might not be expecting?

  • wintermute@discuss.tchncs.de
    link
    fedilink
    English
    arrow-up
    1
    ·
    2 months ago

    Not sure about Marble and Galaxy, but I would avoid printing the rest with less than 0.4. Most wood filaments recommend 0.6 or above.

    • filcuk@lemmy.zip
      link
      fedilink
      English
      arrow-up
      2
      ·
      2 months ago

      Correct me if I’m wrong, but the ‘good’ ones have larger wood chips. Cheaper wood infill usually have small bits or dust, which should actually work better at .4 (and don’t look/feel as good).

      • wintermute@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 months ago

        Not sure about that. I would say that in better quality wood filament the particle size is more uniform/consistent.

        Subjectively, I think they look better with a bigger nozzle and layer height, and specially of you sand it.