So I played with all kinds of settings in PrusaSlicer. Nothing changed anything.
The only things that did improve the outcome some was:
-
Forcing the letters to be printed first: then the letters are smooshed and bleed into the background instead of the other way round, which arguably looks better / more legible. Nothing to write home about though.
-
Dropping the first layer’s height to 0.1mm (the other layers are 0.2mm high): that improves the letters a bit.
-
Dropping the first layer’s height to 0.05mm: because the first layer is so thin, it becomes kind of translucent and the wider white letter beneath it sort of show through. The net result is that it drops a kind of gaussian blur onto the lettering, which actually improves them - especially at a distance.
Other than that, there’s just nothing for it. And half of the suggestions I got concern other slicers, and I couldn’t find them or equivalents in PrusaSlicer. Oh well…
I guess that’s as good as it’s gonna get.
I was thinking you could inset the letter boundaries on the letters first setup, but it looks like you only get 2 walls out of the slicer. Maybe try setting it to not outline the walls at all in letter first mode?