Examples could be things like specific configuration defaults or general decision-making in leadership.
What would you change?
Examples could be things like specific configuration defaults or general decision-making in leadership.
What would you change?
Some defaults I would like to see:
Have zsh as the interactive shell (And also have its dotfiles in a better location like XDG_CONFIG_HOME/zsh)
Btrfs with compression enabled and subvolumes set. (Maybe also timeshift installed, not sure because not everyone uses timeshift for btrfs snapshots).
ZRAM (With proper sysctl.conf like PopOS does).
Pacman as the package manager with an Aur helper already installed.
No bloat™ preinstalled, nothing of shipping flatpak or snap by default or even a DE. So I can just boot into a tty without having to do the minimal install from zero.
Comply with the FHS and XDG specs (Arch fucking installs packages to /opt and doesnt set ~/.local/bin as part of PATH)
Dont break userspace (arch did this recently with an update to glibc that removed a patch that breaks steam games)
Edit: Also forgot to mention:
And enable/automate maintenance services for BTRFS. For example:
balace
should be run on heavily used system disks orscrub
could help detect errors even on single disks.Could you explain the preference of ZRAM over ZSWAP? I thought the latter was the more advanced and better performing solution. Is there some magic in Pop’s config?
It is just that zram is much faster than zswap because it uses the ram to store compressed memory. Android already uses it by default.
These are worth reading:
https://old.reddit.com/r/Fedora/comments/mzun99/new_zram_tuning_benchmarks/ https://linuxreviews.org/The_Benefits_Of_Having_A_Compressed_zram_Swap_Device_On_Linux
Thanks for the links! I updated my config from z3fold to zsmalloc and adjusted the vm.page-cluster to test these out.
Reading a bit more, I think when using large max_pool_percent (>30) with Zswap the two solutions are more similar than not. A crucial difference is what use-case is more acceptable since Zswap can cause unresponsiveness (and potential lockup) under high memory pressure. While Zram could result in an OOM crash in a similar worst-case scenario.
If you don’t want ANYTHING installed by default you should probably just go for the specialized distros that provide that.
The issue with many of those distros is that it usually means that you have to install everything from 0.
Arch is good at this because the archinstall script speeds it up and you don’t have to choose a DE. But with other distros that use a graphical installer, you are forced to use whatever they ship as the default desktop environment.
edit: And holy shit properly configuring Btrfs subvolumes from 0 is something that I tried with voidlinux and I ended up breaking the entire install.