Why are 3D printers still stuck on stepper motors? Why haven’t we transitioned to servo motors with encoder feedback for positioning?

Is it just too cost prohibitive for the consumer-level? We would be able to print a lot faster and more accurately if we had position feedback on the axes. Instead we just rely blindly on the stepper not skipping any steps when we tell it to move, hoping for the best.

  • KingRandomGuy@lemmy.worldEnglish
    1·
    7 months ago

    BLDC and AC servos maintain full torque at stop too, and have about 2-3× the torque of a stepper of similar size.

    Huh, this is true about BLDCs as well? I remember seeing in a video that BLDCs tend to have very poor torque output when stopped and especially when at low speeds (due to very low efficiency requiring too high currents for drivers to supply), whereas AC motors have a pretty much flat torque curve until they get fairly fast. I’d be interested to know if this is true.