Have an upvote. I’d pay double what Affinity is currently asking to have their products on Linux. Gimp is the opposite of intuitive.
Have an upvote. I’d pay double what Affinity is currently asking to have their products on Linux. Gimp is the opposite of intuitive.
Not all of it though. Like JST plugs, barrel connectors, breadboard pin spacing, etc.
If a driver doesn’t behave properly, the things that are built on top of it won’t work properly either. When that misbehaving driver is not open source, you’re at the mercy of the vendor… It’s common knowledge for over a decade that nVidia drivers are problematic with Linux - especially on laptops. Bad drivers are entirely nVidia’s fault.
I’ve been running Wayland with Intel graphics on my laptop and my desktop runs a Radeon. I’ve had 0 Wayland issues in the past years.
A trigger warning on this post for Android devs would’ve been nice.
I think it’s roughly 2 hours at 60fps, but I don’t know for sure because I have mainly been playing with power connected.
“Deep Rock Galactic: Survivor” has been a blast so far. I’m about 12 hours in.
I’m running DualSense on Arch without issues. It even uses the touch pad for mouse movements when not in-game (Steam).
Make sure to check the docs if you aren’t using Gnome: https://wiki.archlinux.org/title/Gamepad.
My only complaint is the atrocious battery life, but that’s not a Linux issue.
The existence of ArchWiki and the Arch User Respository (AUR). And rolling releases, if that’s your thing.
No issues here with Gnome via Arch on a Framework 13. At 150% scaled if recall correctly.
My only regret for picking team red is that DaVinci Resolve doesn’t support hardware encoding.
why doesnt GNOME have a maximize button
Probably because you can double-click the window ‘bar’ to achieve the same.
I found kdenlive terrible. DaVinci Resolve is much better, but it’s closed source and has some limitations in terms of hardware encoding support (nvidia only).
I’ve used FreeCAD for a few months for small/medium-sized projects and it crashes way too often. It’s pretty much unusable for me. I only use it for CAM these days and do my CAD with OnShape.
The scanning is done on your device. You could theoretically only overload the CSAM reporting feature if such a thing will exist.