The new scrum master is working hard

Teaching by example!

Lovely!

I think pictures of said cat would be greatly appreciated 😉

You can double up the handles, which also spreads the load a bit so they don’t cut into your hand as much. It is mainly for compactness and easy marketing

Guaranteed to last a lifetime, for sure!

It might be an issue with concentricity. If the nozzle is not perfectly centered it creates a step that the filament can snag on. It can then cause the already softened filament to bunch up during deretraction forming a plug in the heat break. I had this issue with cheap nozzles. Everything starts fine and after a few layers it all stops for apparently no reason. Cranking up the heat makes it better for a bit, before making it worse

Witty one-liner