![](/static/66c60d9f/assets/icons/icon-96x96.png)
![](https://lemmy.ml/pictrs/image/1f910de9-62b5-43a9-8c93-94821c945577.png)
I saw these a few days ago and they reminded me that I am a moderator of a sleepy little community. 😆
Thankfully the mod tools were very effective in banning the user and nuking comments.
I saw these a few days ago and they reminded me that I am a moderator of a sleepy little community. 😆
Thankfully the mod tools were very effective in banning the user and nuking comments.
Thanks for the summary. I signed up for it just in case, but don’t think I’ll end up using it. I have a similar experience with Mastodon, but then I was never really into Twitter, either.
I share your feelings on the importance of open platforms. While reddit may have been shitty for a while, the whole third-party apps thing was an eye-opener for me, and started me thinking about (and moving toward) open source.
My next big challenge will be to de-Google, but I’m increasingly up for it. Problem is I have a ton of site identities associated with my email address there, so we’ll see how that works out.
The most galling part of it all for me is knowing that it’s all political theatre of the worst kind. I feel like we’re all just playing our parts while the unrelenting assholes of the UCP use the cover provided by this misdirection to further their tear down of our health care system and enrichment of their petro-buddies. The maga stuff is a perfect buffet line of sewage from which this government carefully selects their next target to generate more outrage and keep Albertans distracted. Fuckers.
No problem! I think you could probably still improve performance with a scrap piece and good clamp pressure before you’d have to spend any money. Good luck!
I would clamp a scrap piece underneath your work piece and then drill. Should take care of the tear out better than tape.
The other way to go would be to use a lipped brad point bit or a forstner bit depending on the size of your holes. Those bits have a cutting edge around the circumference of the hole to prevent chatter when starting to drill and to produce a cleaner pass. A good set of brad points will cost you $100 or so but are a great investment imo.
Sponsored monthly! Way to go everyone, this is awesome. Contributing feels like something good I can do in the face of a whole lot of bad in the world rn, and I’m grateful this instance exists and is so well supported. 🫡 🙏